Boot Loop / Help with Mod Chip

[ace9094]

if your xbox can still boot original xbox games then run any original xbox game that was produced after the release of halo 2.as it lets you install the newest version of the ms dash.

 

 

I now have a new issue..... The plot thickens

 

 

 

The xbox has been unpugged since this thread was started and now lost the time and date so wont boot games lol

 

HOWEVER, I may have a solution, This is a mod chip I have but i have no connectors or wires...

 

 

The chip says X2 Lite Ext. on the bit with 3 switches but I cant find anything about it

 

anyone where I can get the missing connectors or what they are called, and a wiring diagram

[PhilExile]

This is a later version of the chip, but this install should work. Do you have the pin header attachment?

 

http://www.yoxbox.com/tut/xecuter2-6v1-6/

 

(Your chips full name is Xecuter 2.6 Lite)

 

Did you have that chip and just dig it up?

Edited August 18, 2011 by PhilExile

[ace9094]

This is a later version of the chip, but this install should work. Do you have the pin header attachment?

 

http://www.yoxbox.com/tut/xecuter2-6v1-6/

 

(Your chips full name is Xecuter 2.6 Lite)

 

Did you have that chip and just dig it up?

 

It was inside an old xbox that was givewn to me stuck to the inside metal casing.... There were no wires at all to the chip from the motherboard (also the power board, HDD and heat sync's were missing)

 

So you think I should bin it phil? I found a site in the US that does the 2.6 one you said to get for $32

[Emu Newbie]

Can the xbox run official microsoft games (discs)? If so, just put the game in and go to xbox live - let it put the official microsoft dash onto the console.

 

Just a thought, you may have already tried this one though.

 

Ben

[PhilExile]

It was inside an old xbox that was givewn to me stuck to the inside metal casing.... There were no wires at all to the chip from the motherboard (also the power board, HDD and heat sync's were missing)

 

So it was just loose in the case? Usually, they are fitted onto those pin things.

 

So you think I should bin it phil? I found a site in the US that does the 2.6 one you said to get for $32

 

Well, if were me and I didn't know if the chip worked or not - I would just pay the $32 rather than waste my time dicking around with some chip that may or may not work. Wasting an afternoon soldering sucks!

 

Good luck!

Edited August 19, 2011 by PhilExile